usarus
Personal account
0
Your city:  
 Москва
Your city Москва?
Москва, Корабельная
+7 (925) 562-94-40
Silicone mold
Else
Catalog

№67 Leaf (43 cm) Mould by bigcity_art​

1,170
-+Buy
​ ​Sizes: Length 43 cm on the larger side. The width is approximately 12.3 cm Casting height - up to 11 mm Designed by @bigcity_art Recommendations for use:
Full description
vendor_code15946244993891
article number20380363
All specifications
Only 9 left in stock
Article number: 4534534777
  • Overview
  • Specifications
  • Reviews0

Sizes:
Length 43 cm on the larger side.
The width is approximately 12.3 cm
Casting height - up to 11 mm
Designed by @bigcity_art
Recommendations for use:
1. store Silicone molds in zip - bags (a regular cellophane bag or food wrap is also suitable), so that dust and small specks do not stick to them.
2. never use metal tools to remove the product from the mold.
3. Store molds so that they do not deform. To avoid deformation of the mold, store it on a solid substrate (for example, on a cutting Board, which is just as convenient to use as a portable tablet when the mold is filled in and the drying process is underway).
Keep away from metal and other objects that may damage the surface of the silicone mold, at room temperature, in places where there is no access to sunlight.
4. Never place the silicone mold on a heating element and do not hold the torch in one place.
5. Never clean with abrasive means.
6. before use, it is recommended to wash the mold with warm soapy water or any neutral detergents, without using hard and scratchy fabrics. Dry thoroughly before working directly with the resin. You can dry it upside down so that the dust does not accumulate at the bottom of the mold or in a suspended form (you can also wipe it dry with soft paper napkins).
7. To clean the dust from the surface, you can use masking tape.
For perfect gloss and product protection, we recommend that the finished product is covered with a protective layer of Protect Resin.
8. to avoid sticking the finished product to the mold surface when pouring resin, we recommend removing the finished product no later than 11 hours
9. level horizon set on the inside of the mold, if there are not large distortions on the work surface, then align according to the level.

Designed by @bigcity_art

To avoid sticking the finished product to the mold surface when pouring resin, we recommend removing the finished product no later than 11 hours

vendor_code15946244993891
article number20380363

№67 Leaf (43 cm) Mould by bigcity_art​ reviews

Categories:Silicone moldTraysOther formвсе молдыМолды

Catalog